Mining Hardware

Pushing the Gridseed 5-chip ASICs to the Maximum with a Voltmod

gridseed-68-kohm-r52-resistor-mod

So we’ve replaced the R52 with a 68 kOhm resistor, assembled everything up (do not try to run the ASIC disassembled with this mod as you can burn the voltage regulators in a matter of a few seconds). Firing up the ASIC has shown a total power usage of about 58-61W, so pretty much what we have planned initially, however the problem was that the Gridseed device did not want to function properly at that voltage after the modification. It simply did not send any shares back to the server, neither it was showing any HW errors, through apparently the device was working and communicating with the miner software. so we do not recommend to push things so much trying to get the maximum performance regardless of the power usage, better stay at at the reasonable recommendation by using a 47 kOHm resistor which should get you close to 500 KHS at about 20W, running the miners stable at about 1150-1163 MHz. Even if we were able to get the device working properly with the 68 kOhm resistor mod and with 60W power usage it wouldn’t be reasonable to get just about 100 KHS more with an extra 40W of power. You could of course try resistors with values in between 47 and 68 kOhm to see where the maximum would be, but for us it is not reasonable to get just a few more extra KHS with double or triple the power used. Still feel free to experiment and report your finding and as usual be very careful not to burn your hardware while experimenting with it. If you go with more than 47 kOhm resistor be extra careful if running the device with the bottom of the cooler not attached as you can easily burn the voltage regulators of the ASIC!

Related posts

New Innosilicon A2 Scrypt ASIC Miners and Lower Prices

admin

Bitmain AntMiner U1 USB Bitcoin ASIC Power Usage and Performance

admin

Integrated Intel GPUs that you can Mine Crypto Coins On with OpenCL

admin